Partner Area
Eiger Design - Home of the J-Testr
  • Home
  • Systems
  • J-Testr Core
  • Support
  • STANAG 4781
  • Consultancy
  • Partners
  • Contact
  • Events
  • Eiger Labs
  • EPickNPlace
  • Home
  • Systems
  • J-Testr Core
  • Support
  • STANAG 4781
  • Consultancy
  • Partners
  • Contact
  • Events
  • Eiger Labs
  • EPickNPlace

J-Testr Timer Breakout Card

About

The Timer Breakout card has each of its two banks equally split into IN and OUT groups with each group having a BNC connection associated with it. This allows for easy connection to high-speed signal generators and oscilloscopes for evaluation purposes.

The IN BNC connections each have 50-ohm termination and are attached to the lower 8 bits of the associated bank. The Timer Card I/O line to be tested can be selected with a 0603 SMT low value resistor, by default this is connected to bit 0.

The OUT BNC connections are sourced from the upper 8 bits of the associated bank. The Timer Card I/O line to be tested can be selected with a 0603 SMT low value resistor, by default this is connected to bit 8. The OUT connection can also be used for inputs, however without any 50-Ohm termination.

Each bank's VCC supply can be measured at clearly identified 1mm diameter test-point holes.

The Timer Breakout card UserIO (GPIO) lines are taken to eight clearly marked 1mm diameter test-point holes. The card also contains 4 extra common grounding points.

Picture

​ Schematic (PDF also available on download page)

Picture
Picture
Picture
Eiger Design GmbH  © Copyright 2021.
All rights reserved.