Partner Area
Eiger Design - Home of the J-Testr
  • Home
  • Systems
  • J-Testr Core
  • Support
  • STANAG 4781
  • Consultancy
  • Partners
  • Contact
  • Events
  • Eiger Labs
  • EPickNPlace
  • Home
  • Systems
  • J-Testr Core
  • Support
  • STANAG 4781
  • Consultancy
  • Partners
  • Contact
  • Events
  • Eiger Labs
  • EPickNPlace

J-Testr+ Bed of Nails Customisation

Eiger Design GmbH offers a full Bed of Nails customisation service to suit the specific requirement of a customer’s UUT device. The customisation includes all, or some, of the following services. All fixture customisations are provided with a parts list, maintenance guide and user guide documents.
- Mechanically UUT mounting and holding
- Electrical pinning bottom PCB side
- Board location marking
+ Electrical pinning top PCB side
x Pylon interface
x Top/bottom connector mating (Std and RF up to 6GHz)
x Side connector mating (Standard and RF up to 6GHz) 
x Top/bottom LED measurement (including electronics)
x Closed cover sensor
x Fixture contacted sensor
x UUT presence sensor
x Component fitted sensor
x Cover locking mechanism
x Automatic cover opening
x BSA (FEA) analysis
x Pneumatic options
x Shorting and of insulation plates

- Standard Features
+ Consider only  bottom pinning for cost sensitive applications
x Cost options
Available electrical contacting technologies include:
​
- 100mil pitch
- 75mil pitch
+ 50mil pitch
x 40mil pitch
x Connector mating
x RF connection to 6GHz
​

- Standard
+ Cost option

x Not suitable for low cost applications
Available LED contacting technologies include:
​
- 5mm pitch
+ 3.5mm pitch
x 1.3mm pitch

​

​

- Standard
+ Cost option

x Not suitable for low cost applications
For a successful customization the below, minimum, information.data is required to be supplied by the customer:
  • Fully assembled PCB
  • Empty (not populated) UUT
  • Pictures of the top and bottom of the assembled PCB
  • Pictures origination photo
  • PCB Gerber or ODB++ data
  • Paneling information (if applicable)
  • 3D model (preferred) or 3D drawings
  • Test point list with X, Y coordinates (to defined reference point)

Depending on the application, other information that maybe required are:

  • LED X, Y location list with X, Y coordinates and maximum height information
  • Standard connector information
  • RF connector information
  • Wiring information (normally combined with a full ‘turn key’ test solutions)
Picture
Eiger Design GmbH  © Copyright 2021.
All rights reserved.