Partner Area
Eiger Design - Home of the J-Testr
  • Home
  • Systems
  • J-Testr Core
  • Support
  • STANAG 4781
  • Consultancy
  • Partners
  • Contact
  • Events
  • Eiger Labs
  • Home
  • Systems
  • J-Testr Core
  • Support
  • STANAG 4781
  • Consultancy
  • Partners
  • Contact
  • Events
  • Eiger Labs

J-Testr+ GTI Ribbon Cable Kit

About​

The J-Testr+ GTI ribbon cable kits provide four ribbon cables that are suitable for either wiring between the J-Testr+ GTI Pylon (UUT side) and a Connection Card (Pylon) or cabling from the Connection Card ​ to the integrated J-Testr Interposer (Direct Wiring).


​The kits come in the below lengths:​
Picture
40mm (Pylon)
​60mm (Pylon)
80mm (Pylon)
​100mm (Pylon)
250mm (Direct Wiring)
​300mm (Direct Wiring)
Picture
Pylon Wiring information

For Pylon wiring the length required depends on how the Connection Card is designed and, more specifically, the placement of the 40 way ribbon connectors. A simple estimate is to add 20mm to the distance between the rear edge of the Connection Card to the starting edge of the ribbon cable connector as below.
Extra cable length is easily lost with looping, however, for cable losses and signal integrity,  shorter cable lengths are better.
Picture
Picture
The example lengths would be 40mm, 60mm and 80mm

Direct Wiring information

With Direct wiring the length is much less sensitive to the position of the 40 way ribbon connectors on the Connection Card. Under most applications the length of 250mm is adequate, however if the ribbon cable connectors are more toward the front of the connection card a longer cable will be required. 
​
Extra cable length is very easily lost with looping, however, for cable losses and signal integrity,  shorter cable lengths are better.
Picture
Eiger Design GmbH  © Copyright 2021.
All rights reserved.